363-206-295
Administration and Provisioning
Issue 1
December 1997
8-39
Craft Interface Terminal (CIT) Selectable Parameters
8
Table 8-11 describes the parameters provisionable via the CIT. Refer to the command
pages in Section 11, "Commands and Reports" for a complete explanation of
parameters. Additional information on the ID parameter is provided in the “Identifiers”
part immediately following Table 8-11.
Table 8-11.
Parameters Provisionable via the CIT
Parameter
Range
Default
(Note 1)
Command
(Note 2)
Date*
Time*
current value
current value
70-01-01
00:00:00
set-date
set-date
Target ID (system name) *
Shelf number*
CO/RT select*
STS Uneqpd./AIS insert*
20 characters
1-8
CO, RT
Uneqpd., AIS
Site#NE#
1
RT
AIS
set-ne
set-ne
set-ne
set-ne
CIT page length
0 (pager off), 3-150 rows
24
set-link
PM thresholds
See PM Table 10-14
set-pmthres
Alarm holdoff delay
Alarm clear delay
Power minor almn. level
0-30 sec
0-30 sec
MN, MJ
2
15
MN
set-attr-alm
set-attr-alm
set-attr-alm
OC-3 degrade threshold
OC-3 interface applications
Sync Messaging
AIS alm. level of NSA OC-3
Line AIS
10
-5
— 10
-9
1+1, 0x1, video
K byte, S byte, disabled
CR, MJ, MN, NA
10
-6
0x1
K byte
NA
set-oc3
set-oc3
set-oc3/set-oc12
set-oc3
OC-3 line state
IS, NMON
IS
set-state-oc3
STS-1 signal degrade
NSA STS-1 path AIS alarm level
SA STS-1 path AIS alarm level
10
-5
— 10
-9
MN, NR
CR, MN, NA, NR
10
-6
MN
MN
set-sts1
set-sts1
set-sts1
STS-1 channel state
NMON, AUTO †
AUTO †
set-state-sts1
STS-3c signal
degrade threshold
NSA STS-3c path AIS
alarm level
SA STS-3c path AIS
alarm level
10
-5
to 10
-9
MN, NR
CR, NA
10
-6
MN
CR
set-sts3c
set-sts3c
set-sts3c
See notes and footnotes at end of table.
