363-206-295
Commands and Reports
Issue 1
December 1997
11-3
Addresses
1
1
Table 11-1 specifies the valid addresses for slots, lines, ports, channels, paths,
cross-connections, and operations interfaces. Where lists of items appear in
braces { }, and one (and only one) of these items may be used to form the
address.
Each address is made up of several components that are combined to indicate a
specific location on the DDM-2000. The following list shows the potential values
for each address component. Refer to this list when reviewing Table 11-1:
slot type:
Possible values are:
main, m, fn, ls, tg, sysctl,
auxctl, tsi, userpanel,
and
all
.
group:
Possible values are:
m, a, b, c, d,
and
all
.
Note carefully in Table 11-1 when this value is followed by a dash (-)
and when it is not.
slot within a group (abbreviated as slot):
Possible values are:
1-8,
and
all
.
line:
Possible values are:
1, 2
and
all
.
This identifies a line within a slot. Note carefully in Table 11-1 when
all
is not allowed.
STS-1:
Possible values are:
1-12
, and
all
.
special:
Possible values are:
cit, dcc, tbos, partlm, x25, env,
cont, lan,
and
ref.
environmental alarm or control point (abbreviated as alm/cont point):
Possible values are:
1-21,
and
all
.
