363-206-295
Commands and Reports
11-16
Issue 1
December 1997
Starting a CIT Session
1
1
Procedures in the “Operation and Maintenance” section of this manual describe
how to “Connect a CIT and Establish a Session” with the DDM-2000.
CPro-2000
1
1
CPro-2000 is a software package from Lucent Technologies to help users of
DDM-2000 Multiplexer systems set up and use an advanced, yet simple, craft
operations environment on a personal computer using
Microsoft* Windows*
3.1 in
the enhanced mode. CPro-2000 provides the user with the normal CIT access to
DDM-2000 as well as a mouse-driven graphical user interface (GUI). The user
may issue commands to DDM-2000 by using the mouse to select items from a
menu and/or objects from the graphics display.
CPro-2000 Release 3.0 and later supports DDM-2000 OC-3,OC-12 and
FiberReach Multiplexers, as well as FT-2000 OC-48 Systems. For complete
information on CPro-2000, refer to the
CPro-2000 User Manual
, 190-253-101 (for
CPro-2000 Release 3.0) or 365-576-1xx (for CPro-2000 Release 4.0 and later).
Commands
1
1
The following pages provide detailed information about the user interface
commands supported by DDM-2000. Detailed report information is located at the
end of this chapter.
1
1
*
Registered trademark of Microsoft Corporation.
