Lucent Technologies Supplemental Battery Stand J85504D-1 List 16
Issue 2 September 2000
Installation Procedures 6 - 3
Installing HDI
Type Anchors
The HDI Drop-in anchor is an internally threaded, flush mounted
expansion anchor for use in concrete. These anchors me the description
in Federal Specification FF-S-325, Group VIII, Type 1, for expansion
shield anchors.
Refer to Table 6-C for spacing requirements for HDI anchors.
Caution
Use eye protection during this procedure.
1. Adjust depth gauge so anchor
will be flush with the base
material surface.
2. Drill hole with the prescribed
drill bit.
3. Clean hole using a blow-out
bulb or compressed air.
4. Install anchor using proper
setting tool. Drive setting tool
into anchor until shoulder
meets top of anchor.