Lucent Technologies Lineage 2000® Battery Distribution Fuse Bay (BDFB)
Issue 4 March 1998
Product Description 3 - 9
Cabinets may be configured for either top or bottom cable entry.
For bottom feed applications, a List BF should be ordered in
addition to the main list. In either case, the same cabinet is used,
but the cabinet is rotated 180 degrees and the digital meters and
spare fuse holders swap positions.
When ordering fuse panels for the BDFB it is important to
remember the numbering schemes associated with top and
bottom feed applications. Refer again to Figures 3-1 through 3-
4 for fuse panel position numbers for each application. This
information is necessary to communicate where fuse panel with
different configurations should be located on factory orders.
Panel numbering is also stamped on the front of each cabinet at
the factory as an installation reference.
Figure 3-6: 2 foot or 4-1/2 foot extension cabinet
7' Cabinet
7' Cabinet
Frame
Mounting
Hardware
Frame
Mounting
Hardware
Ground
Strap
Ground
Strap
Lucent
Lucent
2'
4-1/2'