Rack doors
....................................................................................................................................................................................................................................
Positioning
............................................................................................................................................................
1
Place the lower hinge-pin of the door into the eye of the Door
Support Bottom. The following rack doors should be used:
•
CC848795001 in case of an ETSI-2 rack.
•
CC848795019 in case of an NEBS-2000 rack
NOTE: The mentioned comcodes represent always a pair of rack
doors (left and right).
............................................................................................................................................................
2
Pull down the locking mechanism at the top of the door.
............................................................................................................................................................
3
Lock the door by releasing the locking mechanism of the upper
hinge-pin in the eye of the Door Support Top.
..........................................................................................................................................................
4
In the case of ...
Then ...
an ETSI-2 rack
no grounding is needed between doors
and rack frame.
an NEBS-2000 rack
connect the Ground Strips —
DC1005100 (item 1) at the top and
bottom of each rack door.
Side panel and doors installation
System cabling and final assembly
....................................................................................................................................................................................................................................
365-374-074
Issue a, April 2002
Lucent Technologies
4 - 7 3
E
N D
O F
S
T E P S
............................................................................................................................................................