............................................................................................................................................................
11
Click on the
Select
button.
Result:
On
Screen 2 of 3
both, the source and destination tributary, are
displayed.
............................................................................................................................................................
12
Click on the
Next>
button.
Result:
The
Screen 3 of 3
opens.
The current data of the cross connection are displayed. The
Source NE Name
is greyed out.
............................................................................................................................................................
13
Select
NE-B
as the
Destination NE Name
.
............................................................................................................................................................
14
Click on the
Finish
button to apply your settings.
............................................................................................................................................................
15
Repeat
to
for NE-B.
Be aware of the following differences:
•
As
Source
select the port which is interface to the MS-SPRing.
•
As
Destination
select the port to which the fiber loop is
connected.
•
Select
NE-A
as the
Source NE Name
.
SDH test procedures
Point to point / Ring testing
Span / Ring testing
....................................................................................................................................................................................................................................
365-374-074
Issue a, April 2002
Lucent Technologies
8 - 2 5
E
N D
O F
S
T E P S
............................................................................................................................................................
