17
␣Alarm Clock & Timer␣
The Alarm Clock and Timer features are only
available from the display and cannot be
activated with a feature code. Alarm Clock
causes your phone to beep at a certain time;
you can set only one alarm. Until canceled,
the display shows a bell reminding you that
the alarm is on, and the alarm sounds each
day at the same time. Timer times calls or
other activities for up to 59 minutes, 59
seconds, displaying the elapsed time on your
screen. You must turn Timer off when timing
is over; it does not turn off automatically at
the end of a call.
To set an alarm:
1. Press the
Menu
button.
2. Select
Alarm Clock [AlClk].
3. If your display is English, dial a 4-digit time
from 0100 to 1259 and select
a.m/p.m. to
switch between AM and PM.
If your display is French or Spanish, dial a
4-digit time between 0000 and 2359.
If you make an error, select
Reset and redial.
4. Select
On.
5. Press the
Home
button. The display shows
a bell to remind you that an alarm is on.
To cancel the alarm:
1. Repeat Steps 1 and 2 above.
2. Select
Off.
3. Press the
Home
button. The display no
longer shows a bell.
To time a call or other activity or to turn Timer
off:
1. Press the
Menu
button.
2. Select
Timer.
␣Account Codes␣
To program:
See
Programming Buttons & Settings
In some companies, you enter an account code
before or during a call to indicate client billing
information. You may be
required to enter an
account code for all outside calls, or an
account code may be optional for incoming
and outgoing calls. Check with your system
manager for account code operation and
account codes.
You can program a button for this feature and
label it
Acct
(p. 18) to
program an account code on an outside
Auto Dial
button.
To enter an account code:
1. Press the button you have programmed,
OR
Press the
Feature
button and dial
82
or
select
Account Code [Acct] from the display.
2. Dial the account code and
#
.
3. Lift the handset or press the
Speaker
button to make a call. (If necessary, press an
outside line or
SA
button.)
4. Dial the outside number (including dial-out
code,if required).
To enter or change an account code during a
call (the other party cannot hear your entry),
follow Steps 1 and 2. If you enter an account
code for an incoming call before it arrives, you
cannot change that code during the call.
␣Alarm␣
To program:
See
Programming Buttons & Settings
If there is something wrong with the system,
the red light next to your console’s pro-
grammed
Alarm
button goes on. Report the
alarm immediately to your system manager.
Press the
Alarm
button, then the
Inspct
button, to see how many problems the system
is reporting.
The red light stays on until the problem is
cleared by your system manager.
Often-Used Features
