........................................................................................................................................................................
IMPORTANT SAFETY INSTRUCTIONS
READ AND UNDERSTAND ALL INSTRUCTIONS
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the literature
accompanying this product.
When installing, operating, or maintaining this equipment, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
1.
Read and understand all instructions
2.
Follow all warnings and instructions marked on this product.
3.
This product should be only operated from the type of power sources indicated on the marking label.
4.
Connect this product only to the type of power sources recommended by Lucent Technologies. For
information on the powering instructions, consult the Installation Manual (DMXplore 365-372-334).
5.
For information on proper mounting instructions, consult the Installation Manual (DMXplore 365-372-334).
6.
Install only equipment identified in the Installation Manual (DMXplore 365-372-334). Use of other
equipment may result in improper connection of circuitry leading to fire or injury to persons.
7.
All metallic telecommunication interfaces should not leave the building premises unless connected to
telecommunication devices providing primary and secondary protection, as applicable.
8.
Do not use this product near water, for example, in a wet basement.
9.
Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage to
the product.
10.
Use caution when installing or modifying telecommunications lines.
11.
Never install telecommunications wiring during a lightning storm.
12.
Never install telecommunications connections in wet locations.
13.
Never touch uninsulated telecommunications wires or terminals unless the telecommunications line has been
disconnected at the network interface.
14.
Never touch uninsulated wiring or terminals carrying direct current or ringing current, or leave this wiring
exposed. Protect and tape uninsulated wiring and terminals to avoid risk of fire, electric shock, and injury to
service personnel.
15.
Never push objects of any kind into this product through slots as they may touch dangerous voltage points or
short out parts that could result in a risk of fire or electrical shock. Never spill liquids of any kind on the
product.
16.
Slots and openings in the unit are provided for ventilation, to protect it from overheating, and these openings
must not be blocked or covered. This product should not be placed in a built-in installation unless proper
ventilation is provided.
Summary of Contents for Metropolis DMXplore
