...........................................................................................................................................................................................................................................................
Operational Tests
Overview
5 - 2
Lucent Technologies - Proprietary
See notice on first page
365-372-327 R2.0
Issue 1, October 2003
Tools, Test Equipment and
Accessories
Listed below are the tools, test equipment and accessories necessary to
perform the procedures in this section.
Quantity
Description
Comments
Screwdriver(s)
A screwdriver(s) with the appropriate
head(s) is (are) required for securing the
mounting screws, repositioning the
mounting brackets, installing the interfacing
cables, and for setting the circuit breakers to
the OFF position.
1
ESD Wrist Strap
A wrist strap must be worn when handling
circuit packs. Use the electrostatic discharge
(ESD) jack provided on the shelf.
1
Multimeter (Optional)
The voltmeter must be capable of
measuring DC voltage in the 40 to 60 volt
range. The use of the voltmeter is optional
since the shelf will alarm or shut down if the
proper voltage is not supplied.
1
DS1 Error Rate Test Set
A DS1 error rate test set is required for
testing of DS1 cabling. A T-BERD 211 or
equivalent is recommended.
1
DS3 Error Rate Test Set
A DS3 error rate test set is required for
testing of DS3 cabling. A T-BERD 305 or
equivalent is recommended.
2
LC-type Optical Fiber
Jumper (108918269)
Two optical fiber jumpers with LC type
connectors are required to optically loop the
Metropolis
®
DMXtend shelf for test
purposes.
1
Personal Computer (PC)
See PC Minimum Requirements (page 3-2).
1
RS-232 Interface Cable
8-ft. long RJ45 to 9-pin D-sub serial cable
(Comcode 848748869).
