...........................................................................................................................................................................................................................................................
Installation Tests
Clearing Alarms
4 - 6
Lucent Technologies - Proprietary
See notice on first page
365-372-327 R2.0
Issue 1, October 2003
............................................................................................................................................................................................................................................................
Clearing Alarms
Description
In order to clear standing alarms the Metropolis
®
DMXtend
synchronization will be optioned for "Free Running". The DCC will be
disabled in order to prevent DCC alarms from being generated due to
the optical loopback on the main OLIUs.
Step 1
Use the scroll bar in the
Command Builder
window to scroll down to
the
set-syncn(free run)
command
............................................................................................................................................................................
Step 2
Click on the
set-syncn(free run)
command.
Result:
The
set-sync:lt-dmxtend:all:ctag::frng;
command
should be displayed in the command window to the left of the
Send
button.
............................................................................................................................................................................
Step 3
Click
Send
to issue the command.
Result:
The
Response Window
should display the command
followed by a
COMPLD
indication.
............................................................................................................................................................................
Step 4
Use the scroll bar in the
Command Builder
window to scroll down to
the
ent-fecom
command.
............................................................................................................................................................................
Step 5
Click on the
ent-fecom
command.
............................................................................................................................................................................
Step 6
Under the
Parameters
section,
<FECOMAID>,
click on
dcc-{m}{1}-
{1}.
............................................................................................................................................................................
Step 7
Under the
Parameters
section,
<FECOMSB>,
click on
COM={ENABLED}.
Double click on
{ENABLED}
and choose
DISABLED
Result:
A command similar to the following example should be
displayed in the command window to the left of the
Send
button.
Example:
ent-fecom:lt-dmxtend:dcc-m1-1:ctag:::COM=DISABLED;
