Lucent Technologies Metropolis DMXtend Installation Manual Download

Page: 185 / 350

Installation Tests

Local Equipment and Cross-connect Tests

...........................................................................................................................................................................................................................................................

4 - 1 1

Lucent Technologies - Proprietary
See notice on first page

365-372-327 R2.0
Issue 1, October 2003

............................................................................................................................................................................

Step 7

Under the

Parameters

section,

<VT1AIDCRSDST>

, click on

{a}-{1}-

{1}-{1}

Double click on {a} and choose the Function Group where the LNW6/
LNW7/LNW8/LNW39 is located.

Result:

A command similar to the following example should be

displayed in the command window to the left of the

Send

button

Example for Function Unit

ent-crs-vt1:lt-dmxtend:m-1-1-1-1,a-1-1-1:ctag::2WAYPR;

This command creates a cross-connect to map the first DS-1 of a
LNW39 circuit pack in Function Unit

A-1

and/or

A-2

slot(s) to the first

VT1.5 within the first VT Group of STS-1 of the Main OLIUs.

............................................................................................................................................................................

Step 8

Click

Send

to issue the command.

Result:

The Response Window should display the command

followed by a

COMPLD

indication.

Requirement:

The DS-1 test set should indicate it is receiving an

error free QRSS signal with B8ZS formatting.

If an error free signal is not received:

•

Verify that the DS-1 line coding format is set to B8ZS using the

rtrv-t1

command

•

Verify that the LBOs are set according to cable length using the

rtrv-t1

command (see Setting DS1, and DS3/EC1 LBOs (page

4-3).

•

Check DS-1 cabling for proper connections.

............................................................................................................................................................................

Step 9

Use the scroll bar in the

Command Builder

window to scroll down to

the

dlt-crs-vt1

command.

............................................................................................................................................................................

Step 10

Click on the

dlt-crs-vt1

command.

............................................................................................................................................................................

Step 11

Under the

Parameters

section,

<VT1AIDCRSSRC>

, click on

m-1-{1}-

{1}-{1}

............................................................................................................................................................................

Step 12

Under the

Parameters

section,

<VT1AIDCRSDST>

, click on

{a}-{1}-

{1}-{1}