...........................................................................................................................................................................................................................................................
Operational Tests
Automatic Protection Switching and Alarm Test
5 - 1 4
Lucent Technologies - Proprietary
See notice on first page
365-372-327 R2.0
Issue 1, October 2003
The
FAULT
LED on the second circuit pack will light for several
seconds then extinguish.
On the SYSCTL, the
MN
alarm extinguishes.
............................................................................................................................................................................
Step 6
Repeat this procedure for each equipped Function Group.
............................................................................................................................................................................
Step 7
Swap circuit packs from another function group to test any unequipped
function slots.
............................................................................................................................................................................
Step 8
Check off the appropriate box in Appendix E, Installation Checklist.
...........................................................................................................................................................................
End of Steps