...........................................................................................................................................................................................................................................................
Fiber Labeling
Fiber Labels
F - 4
Lucent Technologies - Proprietary
See Notice on first page
365-372-327 R2.0
Issue 1, October 2003
............................................................................................................................................................................................................................................................
Fiber Labels
Introduction
If pre-printed labels are not available, use a label-maker to create labels
for each end of each fiber. The label should include:
•
rack location
•
circuit pack
•
port
•
direction (IN,OUT)
Labeling the Fibers
To apply the labels to the connectors, use the following procedure.
............................................................................................................................................................................
1
Remove the appropriate label from the backing sheet or the label
maker.
............................................................................................................................................................................
2
Apply the label to the strain relief boot, close to the body of the LC
connector.
............................................................................................................................................................................
3
Adhere the end of the label with the printed text first.
............................................................................................................................................................................
4
The label must be oriented perpendicular to the main axis of the
connector.
............................................................................................................................................................................
5
Wrap the label around the boot so that the second wrap is directly on
top of the first wrap. (The label will wrap around the boot
approximately two times). The text is printed diagonally on the label so
that it can be read when applied the correct way.
Important!
Do not apply the label diagonally to the boot. The
label must wrap directly on top of itself for the adhesive to work.
E
N D
O
F
S
T E P S
...........................................................................................................................................................................
End of Steps