255-700-025
4-53
PacketStar
™
Access Concentrator 60 User Guide
, Issue 1
Release 6.3.0
Chapter 4 Configuring the Basic System
PNNI System-Wide Configuration
6
Press
Ct r l+A
to
Create Route Address Entry
.
The route is completed.
7
Using the instructions in the appropriate
PacketStar™ Module User Guide
,
configure a second port with the ATM UNI interface (you must create
the ATM UNI interface if it does not yet exist) and bring the ATM UNI
interface into service.
8
To add additional route addresses, repeat this procedure.
End
Configuring PNNI Metrics
The Metrics table displays the PNNI parameters associated with a PNNI entity,
or connectivity between a node and a reachable address or transit network.
The AC 60 system learns such information as advertised service categories,
bandwidth, and so on. You can also view traffic patterns and other
information about routes advertised on other nodes in the Route Address
Table window (see Figure 4-28).
Begin
Configuring PNNI Metrics
1
From the PNNI Route Address Configuration window, select the
View
Metrics Table
command.
The PNNI Metrics Table window is displayed (see Figure 4-30).
Operational
Status
Inactive
(default)
Indicates that the reachable address
prefix is not operationally valid and not
being advertised by this node.
Advertised
Indicates that the reachable address
prefix is operationally valid and being
advertised by this node. The system will
display this value if the ATM PNNI 1.0
interface is in service, and at least two
nodes must have connectivity to each
other.
Table 4-14. Field Values for the PNNI Route Address ConfigurationWindow
Field Name
Values
Description
