PARTNER II System Programming
Assign the Transfer Return Extension (#306)
This procedure ensures that a call routed by the system to a user’s extension, that
does not answer and does not have coverage, is transferred to the System
Operator’s extension (normally extension 10). Assign a Transfer Return Extension for
each PARTNER MAIL system extension as described below.
1.
2.
3.
4.
5.
6.
Locate the two or four PARTNER MAIL system extensions on PARTNER II
Form B1.
Access System Programming as described in “Accessing System
Programming” and press [
#
] [
3
] [
0
] [
6
].
Enter the first PARTNER MAIL system EXTENSION at the
Trns Ret Ext
prompt.
Enter the System Operator's EXTENSION (normally [
1
] [
0
]) at the
Data
prompt.
To program another extension press
[
Next Item
]
or
[
Prev Item
]
until the extension
number appears on the display, then repeat step 4.
Choose:
— Press [
#
] and a system program number to program another feature, or
— Press
[
Next Procedure
]
or
[
Prev Procedure
]
to program another feature, or
— Press
[
Feature
]
[
0
] [
0
] to exit programming.
Program the PARTNER II System
for the RMD
Use the following procedures to remove all lines from the RMD (Remote
Maintenance Device), and to assign Automatic Extension Privacy to the RMD.
Remove Lines Using Line Assignment (#301)
1.
2.
3.
4.
Refer to PARTNER II Form B1 to determine the RMD extension, and refer to
PARTNER II Form B2 to determine the customized extension settings for the
RMD.
Access System Programming as described in “Accessing System
Programming” and press [
#
] [
3
] [
0
] [
1
].
Enter the RMD EXTENSION at the
Extension:
prompt.
Press
[
Remove
]
to remove all existing line assignments.
3-6
Initial System Programming
