PARTNER II System Programming
CO Line Coverage
Use the Group Call Distribution (#206) procedure to assign outside lines to the VMS
Line Cover option. PARTNER MAIL answers calls on these lines after four rings. If a
Line Owner is assigned (see note below), PARTNER MAIL transfers the caller to the
Line Owner’s mailbox. If there is no Line Owner assigned, PARNTER MAIL transfers
the caller to the General Mailbox. Callers at remote sites may also use Group Call
Distribution to access PARTNER MAIL if the Automated Attendant Service is not in
operation by pressing [
✱
] [
7
] when the PARTNER MAIL system answers.
1.
2.
3.
4.
5.
6.
7.
Locate Lines on PARTNER II Form A which have “VMS-MAIL” written in the
“Line Coverage” column.
Access System Programming as described in “Accessing System
Programming” and press [
#
] [
2
] [
0
] [
6
].
Press [
7
] at the
Group:
prompt,
Enter a two-digit Line number at the
Line:
prompt.
Press
[
Next Data
]
until
3 VMS Line Cover
is displayed.
To program another line, press
[
Next Item
]
or
[
Prev Item
]
the line number
appears on the display, then repeat the previous step.
Choose:
— Press [
#
] and a system program number to program another feature, or
— Press
[
Next Procedure
]
or
[
Prev Procedure
]
to program another feature, or
— Press
[
Feature
]
[
0
] [
0
] to exit programming.
NOTE:
To assign Line Ownership, perform the PARTNER MAIL Line Ownership
procedure in Chapter 4 of this guide.
Programming Call Answer Service
3-11
