PARTNER MAIL - Initial Programming
Changing the System Administrator’s
Password
■
Factory Setting: 1234.
Change the factory settings for System Administrator’s password to
prevent unauthorized programming of the system.
N O T E :
1.
2.
3.
4.
5.
6.
7.
If the System Administrator changes the password and forgets it, or a new
System Administrator does not know the password set by his or her
predecessor, contact the AT&T Helpline or an authorized AT&T dealer to reset
the password after obtaining proper authorization from the customer. The
AT&T Helpline phone number is listed on the inside cover of this guide.
Press
[
Intercom
]
[
7
] [
7
] [
7
] or a preprogrammed button.
Enter the System Administrator’s MAlLBOX (initially [
9
] [
9
] [
9
] [
7
]) and press
[
#
].
Enter the System Administrator’s PASSWORD (initially [
1
] [
2
] [
3
] [
4
]) and press
[
#
].
The Voice Mail Menu plays.
Press [
5
] to program your new password.
The prompt asks you to enter your new password.
Enter your PASSWORD followed by [
#
].
The prompt asks you to re-enter your new password.
Enter your PASSWORD followed by [
#
].
The new password is now active.
Press [
✱
] [
#
] to return to the Voice Mail Menu, then press [
9
] to access the
Administration Main Menu or hang up to quit.
Programming System Parameters
4-9
