The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
Installing Your Voice Terminal
Page 3-7
Wiring Information
3
2. For all voice terminals, snap one end of the line cord into the “LINE” jack
and the adjunct cord (if applicable) into the Adjunct jack on the bottom of
the voice terminal. (The Adjunct jack is labeled
on all sets except the
8411, on which the jack is labeled “ADJUNCT.”) For more information on
installing adjuncts, refer to the section “Attaching Adjunct Equipment.”
NOTE:
If you are routing the cords on the 8405D, 8405D Plus, or 8410D
voice terminal and the desktop stand is in the high position, you may
need to place the cords through the long, rectangular opening that
surrounds the jacks and plug the cords into the jacks BEFORE you
insert the desktop stand onto the back of the voice terminal.
NOTE:
If you are routing cords on the 8411, lift the kickstand and place the
cords under the kickstand.
3. For all sets, thread the line cord (and adjunct cord, if applicable) through
the routing channel leading to the top of the desktop stand, as shown in
Figure 3-2, Figure 3-3, or Figure 3-4, according to the type of terminal you
are using. Make sure that each cord is placed securely under the square
tabs in the routing channel.
4. If you are using an 8434DX with an attached 801A Expansion Module, plug
the D6AP-87 cord, shipped with the expansion module, into the Expansion
Module jack on the 8434DX (labeled “EX MOD”) and then plug the free end
of the cord into the jack on the expansion module. The cord should be
threaded through the routing channels on the voice terminal. See
Figure 3-4. For more detailed instructions on installing the expansion
module to the 8434DX, use the instructions titled “801A Expansion Module
Instruction Manual,” shipped with the expansion module.
NOTE:
An 801A Expansion Module can be used ONLY with an 8434DX voice
terminal connected to a DEFINITY G3V3.3 or later switch.
5. For all voice terminals, snap one end of the coiled cord into the Handset
jack (this jack is labeled
). On an 8403, thread the cord into the
channel leading to the side edge of the voice terminal; the handset cord will
then lead off the side of the voice terminal.
!
WARNING:
Do NOT insert the handset cord into the Adjunct jack. It may cause
equipment damage.
