The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
Installing Your Voice Terminal
Page 3-21
Wiring Information
3
To connect an Analog Adjunct to the 8411:
1. Connect the line cord of the Analog Adjunct to the Analog Adjunct jack on
the rear of the 8411 voice terminal.
!
WARNING:
Do NOT connect the Analog Adjunct to the wall jack. It will cause
equipment damage.
NOTE:
The 8411 voice terminal connected to a DEFINITY G3V4, Issue 3,
switch must be optioned to use the appropriate DCP I-channel (either
the I-1 Channel or the I-2 Channel). For administration of the 8411
with the DEFINITY G3V4, Issue 3, and later switches, see
“Administering the 8410 and 8411 Voice Terminal” in Chapter 5:
Switch Administration in this manual.
The PassageWay Button (Button #9) and the
Analog Adjunct Button (Button #10)
The system manager may choose to option Button #9 on the 8411 voice terminal,
the next-to-last button in the second column, (see Figure 3-12 below for the
location of this button) so that the red and green lights next to the button provide
PassageWay status information. [See Table 3-2 (“PassageWay Status
Indications”) on the next page.] If Button #9 is optioned in this manner, it is then
disabled and CANNOT be used as a call appearance button or feature button.
The system manager may also choose to option Button #10 (again, see
Figure 3-12 below for its location) so that its adjacent red and green lights provide
Analog Adjunct status information. [See Table 3-3 (“Analog Adjunct Status
Indications”) later in this section.] If Button #10 is optioned in this way, the button’s
function changes from a call appearance/feature button to a local button that can
be used to send a disconnect signal to the analog adjunct. (See “Sharing the 8411
Telephone Line with the Analog Adjunct” later in this section.)
NOTE:
When the status indication feature is optioned, Button #9 is always used to
monitor the PassageWay connection, and Button #10 is always used to
monitor the Analog Adjunct. No other buttons on the 8411 can be used for
these purposes. If these two buttons are not used for PassageWay and an
Analog Adjunct, they can be used for switch features.
