The Built-in Configurator
Set the Serial Parameters
WaveLAN/EC-S User’s Guide
4-39
tcpbind1a
4
This is the standard binding for the “listen” socket as used by the
passthrough2 protocol (see page 4-35). It can also be used in
combination with the standard passthrough protocol, as an
alternative to the rmpbind described above.
■
transmit try count For non-broadcast data, this specifies the number of
attempts that the WaveLAN/EC-S should make in
transmitting each piece of data to a remote
WaveLAN/EC-S. A transmission may fail if the
destination WaveLAN/EC-S is out of range or turned
off; when this happens, the data would be lost if
additional attempts are not made. This value gives
the user the ability to tell the WaveLAN/EC-S how
diligently to attempt transmission. The maximum
value is 65000. The default value is “infinite”.
■
transmit retry
interval
When attempting addition transmit attempts
(specified with “transmit try count”, above), it can
be useful to additionally specify how long to wait
between attempts. This setting gives that ability. The
value is specified in 1/100ths of a seconds, so that
100 means 1 second. The maximum value is 65000.
The default value is 100.
Parameter
Description
■
protocol
These examples use the TCP protocol, so the value
of this entry is “tcp”.
■
local tcp port
If the type is listen, this will specify the TCP port
number that the WaveLAN/EC-S will wait for
connections on (default=4000).
■
reopen after
shutdown
If the type is listen, the value “on” states whether a
second connection will be accepted after the first
connection terminates.
If the type is connect, this states whether another
connection attempt will be made if the first
connection is closed by the remote computer.
To disable enter the value “off”.
