The Built-in Configurator
A Sample Scenario
4-44
WaveLAN/EC-S User’s Guide
NOTE:
Write down the IP Address value, as you will need it later
on, when configuring the link partner.
5.
Press
-
on your keyboard to confirm your changes, and
return to the Edit Menu.
6.
From the Edit Menu, select the item “RS-232 port (uart0).
a.
Scroll down this menu to display the following section:
[tcpbind1b]
protocol = tcp
ip address = 10.10.10.129
Looking at the highlighted status bar at the bottom of your
screen, you can find this section at Line # 85.
The
[tcpbind1b]
section enables you to enter the unique IP
Address value of the remote Link Partner.
b.
Change the IP Address value to the value that you
assigned/will assign to the remote link partner. You can
use either:
— A unique IP Address from the range assigned to your
organization, or
— The default value 10.10.10.129.
7.
(Optional) If required, change the subnet mask to a value that
matches your IP Addressing scheme.
8.
Press
-
to confirm the changes, and return to the “Edit
Menu”.
9.
Proceed as described in “” on page 4-48 to save the
configuration to your WaveLAN/EC-S device.
10. Repeat steps 1 through 9 to configure the link partner.
11. Power up both devices and your ready to go.
CTRL
W
CTRL
W
