The Built-in Configurator
Set the Serial Parameters
WaveLAN/EC-S User’s Guide
4-35
Passthrough2
4
If you selected the passthrough2 protocol in the section “Software
Parameters” on page 4-27, you can use this section to set the
operating parameters for the passthrough2 protocol.
With passthrough2, there are two sockets:
■
listen
- related to incoming data
■
connect
- related to outgoing data.
NOTE:
Both of these sockets require the TCP/IP protocol.
As in the socket key for the [passthrough] section above, the
values for the passthrough2 key only identify the name of other
sections in the RS-232 menu, which define the network
connection.
■
For the parameter
listen
the default value is the section
(see page 4-39).
■
For the parameter
listen
the default value is the section
