Configuring WaveLAN/EC-S
Set the EC-S Specific Parameters
WaveLAN/EC-S User’s Guide
3-19
The subnet mask value you select should be the same for all
WaveLAN and WavePOINT-II devices in your network.
NOTE:
To allow roaming operation for WaveLAN IEEE devices, all
WaveLAN devices and WavePOINT-II access points
should logically be connected to the same IP subnet.
WaveLAN devices can not roam “over routers”.
3.
In the Gateway field, enter the IP Address of the Gateway, that
provides access to other LAN segments.
Perform File Operations
3
The “Files” section of the EC Management tab, allows you to:
■
■
Load a configuration from file.
■
Save a configuration to file
3
You can use the “Save Config” option to save the current
configuration settings of the device to a file (
*.cnf
) on diskette or
hard disk drive, for example to:
■
Create a back-up copy of the configuration of each WaveLAN/
EC-S device.
■
Create a sample configuration file that you can use as a
template to replicate the configuration when preparing large-
volume roll-out installations.
When saving the file to disk, make sure you select a file name that
allows for easy recognition in the future (e.g.
template.cnf
or
EC_lobby.cnf
).
