The Built-in Configurator
Set the WaveLAN Parameters
4-18
WaveLAN/EC-S User’s Guide
AP Density
4
The Access Point Density parameter controls the roaming
sensitivity of your wireless station. This parameter should be set to
a value that matches:
■
The physical density of the WavePOINT-II access points that
have been installed throughout the wireless network area, and
■
The setting of this parameter in the configuration of the access
points.
!
CAUTION:
Using non-matching values may seriously affect wireless
performance of your wireless station.
Consult your LAN Administrator for the appropriate values that
apply to your network, and use one of the 1-digit numerical values
listed below to select the correct AP Density setting:
Consult the WaveMANAGER IEEE User’s Guide for more
information about the AP Density parameter.
Value
Description
■
1 (=default)
for Low AP Density.
■
2
for Medium AP Density.
■
3
for High AP Density.