Preparation
-1
WaveLAN/ISA Card User’s Guide
2
Installing the WaveLAN Card
2
Preparation
2
Preparing the Card
2
Preparation consists of installing the optional Remote Boot
ROM feature and setting the hardware configuration switches.
Warning!
Static electricity can damage the interface card. To
prevent damage when unpacking and handling the
interface card, you should make sure to discharge the
excess static electricity from your body. You can do this
by touching an earthed metal surface such as the chassis
of your computer.
1
Carefully open the antistatic shipping bag the card
comes in, and remove the card. When handling the
card don't touch any of the components on its surface
or the edge connectors along the bottom of the card.
Follow these guidelines always whenever you
handle the card.
2
If you intend to install the Remote Boot ROM feature,
do so now, following the manufacturer's
instructions.
Setting the Hardware
Configuration Switches
2
The WaveLAN network interface card has a switch block
containing four switches. The first two switches (switches 1, 2)
are used to set the card's I/O base address. Switches 3 and 4 are
used to enable the Remote Boot ROM and select the Remote
Boot ROM's base address.
isa-src.bk : isa-ch2.frm Page 1 Monday, October 14, 1996 1:23 PM
