Troubleshooting
Error Messages
WaveLAN/ISA Card User’s Guide
4-7
Error Messages
4
Messages appear here sorted in alphabetical order of the
text in the message body. However, some messages may
be displayed with the prefix "
WaveLAN:
"
Bad initialization parameter
type for keyword AT_Address
4
Cause:
The driver has detected an invalid I/O Base
Address parameter value in the PROTOCOL.INI
file.
Action: Correct the parameter and reload the driver.
Valid values are:
0300
,
0390
,
03c0
,
03e0
Call code not available
4
Cause:
The WaveLAN card has no call code (required in
Japan).
Action: Contact your local supplier
Card in use by another
program
4
Cause:
Another program was using the WaveLAN card
when this program attempted to access it. The
most likely occurrence of this message is when
an attempt is made to start a diagnostic program
while the network driver is running.
Action: Disable automatic start-up of the driver and
reboot the computer, or boot from a floppy disk.
Run this program again.
Card not found
4
Cause:
The driver or utility could not detect a
WaveLAN card, or the driver could not find a
card at the specified slot.
Action: Make sure the
PORT
parameter in NET.CFG or
AT_Address
in PROTOCOL.INI corresponds to
that set with the switches on the card.
Card not functioning correctly
4
Cause:
Start-up diagnostics detected a malfunctioning
component and has determined that the card
cannot be used.
isa-src.bk : isa-ch4.frm Page 7 Monday, October 14, 1996 1:23 PM
