LucidControl DI4DO4, User Manual (1.0)
2022/02/03
Page 18 of 47
3.2
Digital Output Channel Processing
3.2.1
Output Signal Value Inversion
Digital output channels have an output signal value and a logical output value. The logical
output value
is the current state of the output which can be “0” (cleared) or “1” (set). The
output signal value is calculated by the output handling.
Read and write commands give access to the logical output value.
In the case that
outDi1Inverted
is set to “off”, output signal value inversion is disabled and
the output signal values and logical output values are identical.
In the case that inversion is enabled by setting
outDi1Inverted
to “on” the output signal
value is the inverted logical value. Writing “1” to the output channel value clears the
output.
All output modes support output signal value inversion.
3.2.2
Timing Limits
The output timing resolution specifies the minimum interval for an on-phase or off-phase.
If an on-time or off-time is lower than t
Res
the phase is skipped.
