LucidControl DI4DO4, User Manual (1.0)
2022/02/03
Page 35 of 47
Read counter add setting of input channel 0
LucidIoCtrl
–
dCOM4
–
c0
–
ginDi0AddCounter [ENTER]
inDi0AddCounter=on
3.4.1.3.3
inDi0ResetCounterOnRead
This Bit Parameter controls how to update the counter value after it was read. It is relevant
in Count Mode only.
Parameter
inDi0Flags
Access
Read / Write
Address
0x1501
Parameter bit
inDi0Flags
Values
Bit Parameter
Bit Postion
inDi0ResetCounterOnRead
Bit 1
Default Value
Off
Parameter Type
1 Bit
LucidIoCtrl Command Line Tool
Parameter Name
inDi0ResetCounterOnRead
Parameter Values
on / off
Call (Set)
LucidIoCtrl
–
d[COMx]
–
c[Channel]
-sinDi0ResetCounterOnRead=[Value] {-p} {--default}
Call (Get)
LucidIoCtrl
–
d[COMx]
–
c[Channel]
–
ginDi0ResetCounterOnRead
LucidIoCtrl Command Line Tool Example
Enable counter reset on read for input channel 0 and make the setting persistent.
LucidIoCtrl
–
dCOM4
–
c0
–
sinDi0ResetCounterOnRead=on
–
p [ENTER]
Read counter reset setting of input channel 0
LucidIoCtrl
–
dCOM4
–
c0
–
ginDi0ResetCounterOnRead [ENTER]
inDi0ResetCounterOnRead=on
3.4.1.4
inDi0ScanTime
This IO Configuration Parameter specifies the scan time T
Scan
of the digital input.
T
Scan
defines the scan time interval within the input signal must be stable in order to detect
it as valid.
