FIG 4
FIG 5
FIG 6
Let the seat release go and locate the seat at the
first-stage height.
Repeat the above steps to up-lift the second-stage height
7. Stretch the seat back.
8. Install the battery, no matter it's the very first time or
usual use for travel.
attery-installed Luggie has been
idled for a long period, it might discharge and at low
power level. (2) It's better to take out the battery
when folding and un-folding. If not, be careful not to
touch the power switch to prevent any danger.
9. Armrest Width Adjustment(option): On each side at the
rear of the seat you will find a large black knob.
By simply loosening this knob you are able to slide the
armrests in or out to whatever width you desire.
Re-tighten the knobs fully. You may need a friend to assist
you with this initial setting up operation. This may extend
the width of your Scooter.
The backrest of your seat will not fully fold
forwards if the armrests are positioned too closely
towards one another.
Do not drive your Luggie with the arms
removed or in the raised position.
1.The handlebar of your Luggie is designed to allow you to
position it in a comfortable driving position. It can be locked
into numerous positions or unlocked to move freely for
transportation.
2.The handlebar lock is operated by a black lever positioned
on the right hand side of the handlebar ( see Fig 6 ).
To release the handlebar from a locked position pull the
black lever upwards, the handlebar will now move freely,
but under mild tension. To lock the handlebar into a
comfortable driving position, simply push the black lever
downwards until the handlebar is locked firmly into
position.
3.With the combination of the height adjustment together with
the handlebar movement, you should find a suitably
comfortable driving position.
Always make certain the handlebar locking lever is
fully down and the handlebar is securely clamped onto the
chrome support plates before driving your Scooter. To make
service adjustment of this part, refer to the Care and
Maintenance section of this manual.
Your controls are located on the handlebar console
( see Fig 7 ) they are :
Do Not switch to 'off' when your
You should only switch 'off' when in motion in the case of
an emergency. Continual use in this mode may cause undue
stress to the drive system and damage the main electronic
Warning :
(1) If b
Luggie
Caution :
Warning :
Warning :
Caution :
HANDLEBAR ADJUSTMENT
CONTROL FEATURES
is moving.
Failure to observe this warning will result in the motor
brake being applied suddenly and placing you in a dangerous
situation.
Warning :
Armrest Width Adjustment(option):
Luggie
Caution :
Warning :
HANDLEBAR ADJUSTMENT
CONTROL FEATURES
Warning :
Caution :
Luggie
You should only switch 'off' when in motion in the case of
an emergency. Continual use in this mode may cause undue
stress to the drive system and damage the main electronic
Luggie
FIG 3
7
speed control unit.
Be extremely cautious on slopes. Sit upright in your seat or
your machine could become less stable.
Sleep Time: When you rest your Luggie Scooter with
the electronics switched 'on' you are using valuable battery
power.Our Luggie Scooter will automatically go into a
speed control unit.
Be extremely cautious on slopes. Sit upright in your seat or
your machine could become less stable.
Sleep Time: When you rest your Luggie Scooter with
the electronics switched 'on' you are using valuable battery
power.Our Luggie Scooter will automatically go into a
