12
6.3 Monocouplings
Male coupling
Female coupling
Dust caps
Before coupling, remove dust caps, then connect male and female couplings and turn locking
sleeve of the female coupling in direction "1" until the locking sleeve latches. The connection
is then made and secured. The decoupling is accomplished by turning the locking sleeve in
direction "0".
The coupling of the devices under pressure is also possible, assuming the connected
equipment is not turned on.
NOTE:
We
recommend
, when ambient temperatures are low and extension hoses /
hose winders are used, connecting the coupling halves in a
depressurised
state
because decoupling may otherwise require a very large exertion of force.
For dust protection, the supplied dust caps must be reattached.
WARNING / CAUTION / ATTENTION!
The monocouplings must
not
be
unscrewed
and/or the hose lines
reversed
!
The hose lines are connected via quick-disconnect coupling halves (female and male) to the
hydraulic pump in such a way that they cannot be reversed.
Summary of Contents for 81-50-35
Page 2: ...2...
Page 27: ...27 13 Notes...