14
Attaching the KSS20 traction device
1. Completely open the spreader arms.
2. Press the release buttons (2.1) on both sides (direction A).
3. With the release buttons (2.1) pressed, push the connector (2) onto the spreader tip (1)
as illustrated in the image (direction B).
4. Let go of release buttons (2.1) and make sure that the locking bolts (2.2) of the connector
(2) securely engage into the location hole of the spreader tip (1).
5. Make sure that the connector (2) is correctly engaged by pulling it by hand.
Operating the traction device
1. Place the traction chain around the traction point or attachment point and form a loop
around the traction point by hooking in the hook.
2. Pull the end of the chain through the connector. To do so, first pull (direction C) the end of
the chain by hand through the insertion opening (2.3). Keep the chain as taut as possible
while doing so.
3. Push a chain link through the duct (2.5) around the retaining lug (2.4) into the holding
slot (2.6) (direction D). Unintentional loosening of the chain is prevented by the retaining
lug (2.4).
4. Before the actual traction process, check the chains once more for a secure hold.
5.
To pull, close the spreader or the combi tool. When pulling, always make sure that the
traction chain is not deflected by obstacles.
6. If the pulling distance is insufficient, it must first be secured with tension chains or other
means. Only then open the spreader and proceed according to points 1 and 2.
C
D
