75
e100_le100_manual_173100085_EN
07/2021
Contact an authorized LUKAS dealer or the LUKAS Customer Service Department directly
if the malfunctions cannot be rectified.
The address for the LUKAS Customer Service Department is:
LUKAS
Hydraulik GmbH
A Unit of IDEX Corporation
Weinstrasse 39, D-91058 Erlangen
Tel.: (+49) 09131 / 698 - 348
Fax.: (+49) 09131 / 698 - 353
http://www.lukas.com
Fault
Check
Cause
Solution
12. Technical data
NOTE:
The following tables contain only the technical data necessary for operation and
storage. Further information about your device is available directly from LUKAS.
Since all values are subject to tolerances, minor differences may occur between the data on
your equipment and the data in the following tables.
The values may also differ because of reading inaccuracies and/or tolerances in the
measuring equipment used. If the given values in the tables are re-converted into different
units, minor inaccuracies may occur when rounded values were used.
Operating pressure:
StrongArm™ e100/le100: 70 MPa / 10000 psi
The useful operating
time between the
individual charging
cycles is less than
5 minutes, despite
charging the batteries
according to the
instructions.
Battery defective
Replace battery
