80
e100_le100_manual_173100085_EN
07/2021
Short description
TLR Series:
Mounting the light to the device:
1. Open the rail clamp tensioning bolt and position the illumination unit at the outer bottom
edge of the accessory rail, so that the rail key matches the rail groove (see illustration
below). Now snap the unit into place by pressing it down until you detect or hear it
clearly engaging.
2. Close rail clamp tensioning bolt until it is tight. The light is fixed now.
3. For demounting proceed in reverse order.
Operating the light:
1. Tap the left side of the paddle switch down = constant light as long as you hold it down.
After release the light goes out.
2. Tap the left side of the paddle switch down and immediately re-press within 0.4 s and
hold = strobe mode as long as you hold it down.
3. Tap down the right side of the paddle switch = constant light. Tap again to stop
illumination.
4. Tap down the right side of the paddle switch and immediately re-press within 0.4 s =
constant strobe mode. Tap again to stop illumination.
14. Lighting unit (optional expansion possibility)
The lighting unit is optional and not offered by LUKAS.
The illustration shows a typical installation of a flashlight as an overview.
Pay always attention to the separate instruction manual provided from the supplier or
manufacturer to mount and operate your flashlight unit as intended.
The light must be separately ordered by the customer at a deliberate supplier.
LUKAS recommends the TLR Series offered by STREAMLIGHT.
WARNING / CAUTION / PLEASE NOTE!
The light or LASER beam of the lighting unit can cause serious injuries or lead
to blindness.
Any accessories attached to the accessory rail are used at
the risk of the user.
Rail groove
Rail key
Accessory rail
