17.10.2008
Page 3
• AMIN 12-125T WH •
1
Safety Instructions
1.1
General safety instructions
Read the operation instructions before starting work and follow the
instructions in operation.
In general, the owner operator of the machine is responsible for ensuring a flawless state with regard
to operation and compliance with the safety regulations. The machine has been built to the state of
the art and recognized safety rules. Nonetheless, there can be hazards to life and limb to the
operator or thirds parties when it is used, or else damage could be done to the machine or other
assets.
Only use the machine:
●
for the intended purpose,
●
in a flawless state regarding safety.
Note the technical data of the machine and the ambient temperatures. The intended use of the
machine is described in this documentation in section
Intended Use
and must be followed. The basic
precondition for safe working with and trouble-free operation of the machine is a knowledge of the
underlying safety instructions and the safety regulations. In addition, the rules and regulations that
apply at the place of use regarding accident prevention, the setting up of electrical and mechanical
systems and radio interference suppression are to be followed. Pay attention to the cleanliness of
the workplace in all maintenance and repair work. You may not eat or drink while working. If you
make any changes on your initiative that go beyond the intended use, the warranty shall be null and
void and the manufacturer shall have no liability whatsoever.
●
The machines are not insulated against contact with electric cables and may not be used
in an atmosphere with a risk of explosion.
It is essential to follow the operation instructions, especially the safety symbols and safety
instructions on the machine and in the documentation.
1.2
Safety instructions for grinders
●
Only use approved abrasive wheels with the appropriate diameter of shaft.
●
The approved working speed of the abrasive wheel must be higher than the speed
of the grinder.
●
Never use a grinder that is not in a proper working state or which has defective components.
●
The abrasive wheels must stored and handled with care in accordance with the instructions of
the manufacturer.
●
Check the abrasive wheel for damage before using it on the grinder. Never use abrasive wheels
that are chipped, cracked or damaged in any other way.
●
The machine must be switched off in the event of a power failure.
