14
- AMIN 12-125 WH -
Stand: 02.03.2007
Vibration acelleration:
< 2,5 m/s
2
Drive:
Vane Air Motor
Accessories included:
- 3 spanners SW4, SW5, SW6, locking spanner
3. Commissioning
The power tool must only be connected to the compressed air network using a
pressure reducer (combination of water separator – pressure control valve –
lubricator). The nominal diameter of the pressure reducer must comply at least with
the hose diameter specified in the technical data. The pressure control valve must be
set to the value of 0.63 MPa.
The pressure reducer must be installed at the working height of the power tool or
above.
The compressed air hose supplied with the machine must be directly connected to
the pressure reducer and must not be lengthened.
The lubricator must be adjusted so as to supply approx. 3 drips per minute at a
pressure of 0,63 MPa. Only oil types quoted in the table below may be used.
In the case of a prolonged period without use (e.g. overnight), the machine must be
disconnected from the compressed air system.
Suitable oil types
Viscosity
Festo Spezialöl
Aral Vitam GF 22
Esso Nuto H 22
Mobil DTE 22
BP Energol HLP 22
Shell Tellus C 22
22 mm²/s(=cSt) bei 40°C
ISO-Klasse VG 22
nach ISO 3448
