15
- AMIN 12-125 WH -
Stand: 02.03.2007
4. Usage
Only grinding tools may be used which are suitable for the power tool and which
permissible operating speed ist equal od exceeds the maximum speed of the power
tool.
The bore diameter of the grinding tool must be equal to the power tool spindel.
Mount the grinding tool by using the supplied spanners and suitable flanges
according to the suppliers instructions. Check the flanges for damages before using.
The mounted grinding tool must revolve freely.
The wheel guard supplied must be used at any rate and assembled in a way that it is
located between grinding tool and operator.
The additional handlebar supplied must be used.
Before changing a tool or undoing the compressed air hose, the power tool must be
disconnected from the compressed air supply.
After a tool change, the power tool must be test run in a safe place (e.g., underneath
the work bench) with the tool clamped in position.
Damaged grinding tools must not be used. If the power tool or the grinding tools
drops, check both for damages and let them test run.
Never put down the power tool before the grinding tool has come to a complete stand
still.
