22
11. Repairs
11.1 General points
Servicing may only be carried out by the manufacturer or personnel trained by the
manufacturer and by authorised LUKAS dealers.
Only LUKAS replacement parts may be used to replace all components (see replacement
parts list) since special tools and compliance with, assembly instructions, safety aspects and
inspections are required (see also chapter "Maintenance and Servicing").
During the assembly work, pay particular attention to the cleanliness of all components
because dirt can damage the equipment!
WARNING / CAUTION / ATTENTION!
Protective clothes must be worn when repairs are being carried out, since parts
of the equipment can remain pressurised, even when idle.
ATTENTION!
Since LUKAS hydraulic cylinders are designed for top performance, only those
components in the replacement parts lists for the relevant unit may be replaced.
Other components on the cylinders may only be exchanged, if:
- You have taken part in appropriate LUKAS service training,
- You have the express permission of LUKAS Customer Service (after request,
verification that permission may be granted. Verification required in each,
individual case!)
When cleaning the equipment, take care not to use any cleaning agent that has
a pH value outside the range 5 - 8!
NOTE:
Before you use couplings from a different company, you must contact LUKAS or
an authorised dealer.
Do not carry out any repairs without the relevant LUKAS replacement parts list,
since this contains the necessary torques for screwed fittings and/or may contain
important additional information.
You will find the LUKAS customer service address in the chapter "Fault analysis“.
Original replacement parts, accessories and suitable hydraulic fluids can be obtained from
your authorised LUKAS dealer.
Summary of Contents for HP 25/ T700R
Page 2: ...2...
