User’s Guide ...
17
16
... LUKAS BLACKBOX
8. Product usage
Power connection
First of all, check whether the SD memory card is inserted into the main body, and then
start the engine with power connected. (Maintain the power button ON)
- While the car is being booted, the version mark is displayed on the segment window after
power supply, and the clock mark changes on the segment window after completion of
initialization.
Recording during parking
1. The parking mode change supports two methods such as manual and auto.
Manual:
Pressing the emergency recording button for more than 2 seconds makes the
buzzer sound go off 2 times, and flashing a word “Par”on the segment window changes
into a parking mode.
Auto:
Checking “automatic conversion into a parking mode” in the user environment
setting flashes a word “Par” automatically 10 minutes after stopping and changes into a
parking mode. After having changed into a parking mode, a word “Par” doesn’t flash but
is displayed continuously.
Recording stops when converting into a parking and travel mode, so there is a loss of
image data.
2. It is stored in the AlwayMovie folder, “parking” is displayed during confirmation in the
private viewer program, and the recording time of J-21 firmware image increases to 10
minutes and the recoding time of JE21 firmware image increases to 6 minutes.
Current image confirmation
1. It is possible to confirm the current image by connecting the Video OUT to the external
input (AV in) function such as navigation, TV, etc. in case of a model with Video OUT. It
can be used to adjust the angle of a black box.
Remove the video output cable during travel after adjusting the angle. A malfunction may
happen due to the connected external device.
Recording during travel
-
Normal recording
: Recording starts while the buzzer sound goes off 5 times after
completion of booting, and is stored in an Always Movie folder.
-
Impact detection recording
: When an impact above the user set sensitivity is
detected(vehicle contact, sudden braking, speed bumps), the event recording starts, the
buzzer sound goes off once, and then the segment window flashes. When an image is
stored in an Event Movie folder, the images of total 30 sec such as 10 sec before and 20
sec after are recorded and stored.
The J-21 firmware is supported only when set in an event recording mode.
- Pressing a manual emergency recoding button stores an image in an Event Movie folder
even though it is not an impact generating situation, and records and stores the images of
total 30 sec such as 10 sec before and 20 sec after.
The J-21 firmware is supported only when set in an event recording mode.
End of recording
Starting the engine of a car turns OFF the power of the product as well. (when using
cigar power) Stopping the product under operation before in the following sequence
helps maintain the lifetime of the product and preserve data.
1. When recording it manually, wait for about 20 seconds and then remove power.
2. When ending the product, a sentence “See you”appears on the segment window, the
buzzer sound goes off 3 times, and then power is turned OFF.
Caution: Separating the SD memory card before ending the product causes an error
to the recorded image. Separate the SD memory card after the product has completely
ended by all means.
3. Completely pulling out the power cable connected to the cigar jack can prevent the
vehicle battery from being discharged.
