Lumag RP-110HP, Instruction Manual

0

8.2  Change of oil

Checking the oil level (Fig. 14)

Check the oil level with the motor shut off and the equipment in horizontal.

•   Remove the refill screw/dip stick (13) and wipe it clean.

•   Put back the screw, without turning it in, take it out and check the level.

•   If the level is close to or under the lower indication “L” on the stick, refuel with oil of advised  

type (see technical specifications) to the upper indication “H”. (= lower end of windings in  

refill hole). Do not overfill!

•   Put back the screw/dip stick and tighten it.

An oil level which is too low, can damage the motor. This will result in all warranties are void.

Replacement of motor oil  (Fig. 15)

•   Empty the oil with the motor warm. Let the motor temperature cool off to hand warm and 

switch it off. 

•   Clean around refill- and drain screws. (13 and 12)

•   Put a container of suitable size under the drain hole.

•   When emptying the oil, remove the screws for refill (13) and drain (12)

WARNING

Old motor oil must be treated in a way which is environmentally correct. We 

recommend that old oil is collected in a closed container and handed over to 

a recycling depot or any other collecting depot for chemicals and oils. Oil may 

never be disposed of in moldering beds or any other water streams, sewage or 

earth deposits.

•  Put back the drain screw and pull it tight.

•  Refill with oil of recommended type with the motor (the equipment) in horizontal, up to    

upper indication “H” on dip stick (= lower end of windings in refill hole). Volume: see    

Technical Specifications

•  Put back the refill screw/dip stick and pull tight.(13)

8.3  Air filter

The air filter consists of two filter parts. Careful cleaning avoids carburetor errors.

Cleaning and replacement of filters

 (Fig. 16)

•   Loosen the wing nut, remove the filter hood (14) and check for holes in it. Replace damaged 

parts. 

•   Dirt on the inside of the hood is removed with a clean cloth.

•   The inner wing nut is removed and the two filters are lifted out.

•   Carefully remove the foam rubber section (16) from the paper section (15). Check for 

damages. In such a case: replace!

•   Clean foam rubber section (16) in warm water and mild soap. Rinse carefully and let dry.

NOTICE

NOTICE

OIL

OIL

MAINTENANCE

RP-110HP_manual_GB.indd   20

04.02.2010   09:23:03