11
Dirty feed-in rollers and feed-out rollers have to be cleaned.
In order to prevent the motor from overheating, regularly check that no dust has accumulated on the
ventilation apertures of the motor.
After a prolonged period of operation, users are recommended to have the machine checked by an
authorized customer service shop.
Tool care
The cutter head, clamping devices, knife supports and knives used on the machine must be freed from
resin regularly as a clean tool improves the cutting quality. This can be done by soaking the clamping
devices, knife supports and reversible knives for 24 hours in paraffin, white spirit or commercially available
resin remover.
Tools made of aluminum may only be deresinified with cleaning agents which do not corrode this kind of
material.
ATTENTION!
Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the
EQUIPMENT. This can influence other equipment (eg. Blinking of a lamp). If the MAINS-IMPEDANCE
Zmax<0.464 OHM, such disturbances are not expected. (In case of need, you may contact your local
supply authority for further information).