.06.
Owner’s Manual & Safety Instructions
Impact driver
8.Assembly
Installing the Battery
Press the unlocking button of the battery,and then insert the charged battery
from the front into the base of the power tool.Push the battery completely into
the base until the stripe can no longer be seen and the battery is securely
locked.
: Use only original batteries with the voltage listed on the name-
plate of your power tool.Using other batteries can lead to injuries and pose a fire
hazard.
Removing the Battery
Press the unlocking button of the battery,and then pull the charged battery from
the front into the base of the power tool.
: Please remove battery from the machine before operate the fol-
lowing installations.
Installing the Bit
Pull the outer ring of chuck to the front position,and insert the bit to the deepest
position.
: Have a pull to the bit and check if the bit has been fastened firmly
and correctly.
Removing the Bit
Pull the outer ring of chuck to the front position,and take the bit out of the chuck.
Operation
: Set the rotational direction switch to the centre position in order
to avoid unintentional starting.
Switch On and Off
To start the machine, press the On/Off switch and keep it pressed.
To switch off the machine, release the On/Off switch, and the machine stops.
: When you release the button, the light will be keep working about
3-5s.The LED lights up when the On/Off switch is halfway or fully pressed, and is
intended to illuminate the power tool’ s direct area of working operation.
