EN
20
Deleting minimum value. DELMIN message is displayed
after deleting. To avoid accidentally exit the menu in the
preview mode, it is recommended to press first the button
, and then the button
and holding them until
DELMIN message is displayed.
Deleting maximum value. DELMAX message is displayed
after deleting. To avoid accidentally exit the menu in the
preview mode, it is recommended to press first the button
, and then the button
and holding them until
DELMIN message is displayed.
Deleting alarm memory - hold down the buttons for 3
seconds. ClrAL message will be displayed after deleting
alarm memory.
All the events of deleting of saved minimum, maximum values and alarm
activation memory are indicated by the meter by displaying an appro-
priate message.
3.3. Programming meter parameters
Programming meter parameters is possible via the RS485 interface
and by direct edition of the parameters using the buttons and the meter
display.
Direct programming process is easy thanks to meter menu, which inclu-
des the settings grouped into sections with all parameters related to a
given functionality, e.g. all parameters of the serial interface are grouped
in the menu
RS485
.
Switching from a normal operation to meter menu is possible by pres-
sing and holding for at least 3 seconds the confirm button
.
If access to change the parameters is password protected, the user will
be requested to enter the access password before entering the menu.
Entering an incorrect password will allow to enter the menu but it will be
not possible to change the parameters - parameters monitoring mode.
Entering a correct password will allow to move to a programming matrix,
the menu after entering the programming mode is shown below.
Summary of Contents for N32H
Page 14: ......
