EN
26
red diode PWR (fig. 2) and a proper setting of an error status value
(table 21*). The readout of the whole configuration imposes launching of
remaining modules, such as:
• LAN module,
• Modbus RTU module for Master mode,
• archive module,
• alarms module,
• statistical data operation module.
After reading the configuration, the device is ready for further work.
At first run, the data logger is using default settings. However, right after
the first activation the data logger configuration ought to be carried out
in order to prepare it for work at a defined environment. Configuration
may be carried out using:
• USB (VIRTUAL PORT COM, Modbus RTU),
• PORT1 (RS-485, Modbus RTU),
• LAN (Modbus TCP, HTTP).
3.1.1. Configuration using USB interface
In order to configure the device through USB interface, the de
-
vice ought to be connected with the mini USB cable to PC. After connec
-
ting a data logger, the operational system will notify of the occurrence of
a new device by displaying a message presented in fig. 4. Found New
Wizard of Universal Serial Bus will activate automatically. Wizard’s sug
-
gestions ought to be followed by selecting installation from the indicated
localization and giving a tract for drivers, which can be found on an at
-
tached CD. Drivers are compatible with the following systems: Windows
2000, XP, Server 2003, Vista, Windows 7, Server 2008 (x86 and x64).
At drivers installation, a message signaling lack of drivers digital signatu
-
re can occur. Ignored them and proceed with further installation.
Fig. 4. Message signaling detection of new device Data logger/Logger
SM61IoT
Summary of Contents for SM61IoT
Page 17: ...17 pl...
Page 31: ...EN 31...