EN
28
Then SM61Config software on attached CD ought to be run
and installation procedures with user guide for first application run ought
to be followed, point
5. SM61Config software*
.
After entering configuration it ought to be saved and the device
restarted so that a new configuration can be entered.
Notice:
After changing the parameters the device should be reset.
3.1.2. Configuration using RS-485 interface
In order to configure the device by interface RS-485, the devi
-
ce ought to be connected using a converter (e.g. PD 10) to a PC. Then
in accordance with tables 19 and 20 from point
10.3. Registers map*
,
which contains registers map of SM61IoT, using own program or a devi
-
ce compatible with Modbus RTU do the data logger configuration.
3.1.3. Configuration using LAN interface
In order to configure the device by LAN interface, the device
ought to be connected to the Ethernet network. Then SM61Config
software on attached CD ought to be run and installation procedu
-
res from user guide for first application run ought to be followed,
point
5. SM61Config software*
.
Notice:
After changing the parameters the device should be reset
.
In case of problems it is advised to restore default parameters
and restart configuration, in accordance with points 3.1.1-3. Restoring
default parameters can be done:
• during device operation time by pressing the button located in the
upper part of the casing,
• by selecting “Default Settings” in the program “SM61Config”
(see point
5. SM61Config software*
).
Summary of Contents for SM61IoT
Page 17: ...17 pl...
Page 31: ...EN 31...