30
EN
2.3. review and change of Parameters
The review and parameter change can be carried out in any controller
operating mode after pressing the
push-button. The name of the first
parameter appears on the upper display, and its value on the lower display.
By means of
and
push-buttons, one can transit to the display
of the next or previous parameter, in the sequence acc. to the table 3.
To measure the parameter value, one must:
- press the
push-button; the parameter value is flickering,
- pressing
and
push-buttons, set the required parameter value,
- press the
push-button again, what means the acceptation
of the new parameter value, or the
push-button, to resign
from the change.
If during 45 sec., none of the push-buttons is not been pressed, the
controller come out from the programming mode.
A renewed pressure of the
push-button ends the review process and
causes the transit to the previous state.