33
EN
Safety code
The safety code serves to secure against the change of introduced data
by non-authorized persons. The factory code is set on 000, what means
that parameters can be modified without the necessity of the previous
introduction of the correct safety code. If the safety code is different from
zero, then at the first pressure of the push-button after the entry into
the programming mode, the
seC
parameter name appears on the upper
display, and the flickering 000 value on the lower display. By means of
and push-buttons, one must give the appropriate code and press
the push-button.
In case of an erroneous code, the
err
message appears. After pressing
whichever push-button, the message disappears and the controller return
to the review option of parameters.
In order to change the safety code, one must first, give its current value
and then, when the
sen
inscription appears, introduce the new value.
In order to reset the safety code to zero, one must display the
seC
parameter, and next, press simultaneously and
and
push-buttons.
19
bud
2
.
4 *6
Baud rate:
%8
2
.
4
- 2400 bits/sec.
*6
%8
- 4800 bits/sec.
1*2
*6
- 9600 bits/sec.
1*2
- 19200 bits/sec.