English
-
33
Chapter 9 Troubleshooting
This chapter describes problems you may encounter while using DC145. If you
have questions, please refer to related chapters and follow all the suggested
solutions. If the problem still occurred, please contact our distributors or service
center.
No.
Problems
Solutions
1
Boot without
power signal
Make sure you have plugged in the power cord.
2
There is no
image output
from DC145
1. Check the power
2. Check all cable connections. Refer to
Chapter 4
Installation and Connections
in this manual.
3. Check the [Source], refer to
7.2 I would like to
switch image sources of Chapter 7 Descriptions
of Major Functions
.
4. Check the settings for the source of the projector.
Please refer to the user manual of the projector.
5. Check if DIP switch is properly set. Please refer to
Chapter 8 DIP Switch Setting
for related settings.
3
Unable to focus
Probably the document is too close. Press [ZOOM -] or
pull away the distance between document and lens,
then press [FOCUS] button on the right side of the lens
for auto focus.
4
The image is
incomplete
Check the Auto Image setting of your projector. Please
refer to the user manual of the projector or check for the
DIP switch setting.
5
Lumens
Document
Camera,
Ladibug™ and
other
applications
cannot be used
simultaneously
Lumens Document Camera
,
Ladibug™
and other
applications cannot be used simultaneously. Only one
application can be executed at a time. Please close the
currently running applications and then execute the
application to be used.
6
DC145 fails to
store images or
react
1. Check to see if the stored data have reached the
maximum size of the SD Card (priority) or internal
memory.
2. Please make sure if the capture function is set to
continuous mode or the time for capture is set to be
long. For the related setting, please refer to
7.11 I
would like to capture images of Chapter 7
Descriptions of Major Functions
.
