Lumex LF1600, Assembly And Operation Manual

LF1600-INS-LAB-RevE15 • LF1600 Stand Assist 

7

5 ASSEMBLY INSTRUCTIONS

Tools required: provided wrench, provided hex key

back casters

base assembly

1.  Place the base assembly on the floor and lock the back casters for ease of 

assembly, as shown above.

flat washer

lock washer

hex bolt

plastic

cap

kneepad

kneepad

 support unit

kneepad

assembly

2.  Insert the kneepads into the kneepad support unit. Install the two hex bolts 

through lock washers, flat washers, and kneepad support unit into nuts as shown 
above. Tighten securely with the provided wrench. Install the two plastic caps on 
the hex bolts. The finished assembly is shown at right above.

carriage bolt

kneepad assembly

kneepad side

support assembly

side support arm

flat washer

lock washer

acorn nut

kneepad

assembly

side support arm

3.  Attach the kneepad assembly to the two side support arms. Face the square holes 

on the side support arms inward; fit the square shoulder of each carriage bolt 
in the square hole, installing each carriage bolt through the kneepad assembly 
bracket and side support arm from the inside as shown above. Install the flat 
washer, lock washer, and acorn nut on the end of each carriage bolt as shown 
above. Do not tighten the nuts; some play in this assembly will be needed to 
assemble the entire unit. The finished assembly is shown at right above.