11
FILLING AND START-UP INSTRUCTIONS (continue)
ADJUSTING HYDROTHERAPY JETS
The Hydrotherapy Jets are recessed and located in the wall of the hot tub.
These jets may be adjusted for both flow rate and direction:
• To adjust each jet’s direction simply rotate the eyeball fitting in the direction desired.
• To adjust each jet’s flow rate, rotate its outer faceplate counter clockwise to increase the flow or clockwise to decrease
the flow.
The bottom jets can not be closed or turned to prevent closure of all jets which would damage the spa.
AIR CONTROL ADJUSTMENT
The air control valve regulates the amount of air mixed with the recirculated water when the jets are running. Rotate the air
control in one direction to achieve the maximum jet pressure and therapeutic action. Rotate the air control in the opposite
direction to turn air off and allow the jets to recirculate water only.
SUCTION FITTING
There are two suction fittings in your spa located at the bottom of each seat. Keeping the suction fitting clean and
unclogged is critical to the safe operation of the spa.
Do not allow anyone to play with or near the suction fitting or skimmer. Suction from these fittings can cause injury and,
possibly, drowning.
SKIMMER
The spa’s automatic skimmer is designed to remove floating debris and contaminants, such as body lotion, by drawing
water through a specially formulated filter cartridge element. It is critical that this filter be routinely cleaned or changed.
(See your retailer for details.)
To clean the skimmer cartridge:
1. Shut off pump.
2. Lift the skimmer lid.
3. Turn counter clockwise and pull up the filter assembly.
4.
Remove the cartridge and thoroughly rinse with a garden hose in clear water until the cartridge is free from dirt and debris.
5. Return the cartridge to the filter assembly. Secure the filter to the skimmer by pushing it downward until it is fully seated
then turn clockwise to lock in place.
6.
CAUTION: Never use the spa while the cartridge is removed.
Summary of Contents for spa-O
Page 23: ...23...
